Integrated Office
Finisher (Optional)
Integrated Office Finisher
Allows you to staple or sort copies automatically. The Integrated OfficeFinisher Center
Tray can hold 500 sheets of 20 lb bond or 80 g/m2 paper in Letter/A4 size or smaller.
Duplex Module
Allows you to make double-sided copies. The Duplex Module can be used when paper
is supplied from Tray 1, 2, or 3. For more information, refer to 2 Sided Copying in the
Copy chapter of the User Guide.
Trays 2 & 3
At the base of the machine, the following optional trays will be available, depending on
the configuration.
• Two Tray Module – Can be added to the standard 1-tray configuration. Each tray
can hold 520 sheets of 20 lb bond or 80 g/m
• Tandem Tray Module – Can be added to the standard 1-tray configuration to provide
high volume paper sources. Tray 2 can hold a maximum of 900 sheets of 20 lb bond
or 80 g/m
of 20 lb bond or 80 g/m
referred to as "TTM" in this manual.
Tray 5 (Bypass)
Allows you to bypass the standard paper trays to print on different sized paper. The
Bypass Tray can hold 100 sheets of 20 lb bond or 80 g/m
B6 (SEF) or Envelope Monarch (LEF) to A3 (SEF) or 11 × 17 inch (SEF).
NOTE: Do not place paper with a length less than 140mm in the Bypass Tray, as this
may cause paper jams and potentially damage the inside of the machine.
Xerox WorkCentre 7132 System Administration Guide
Staple Cartridge
2
paper in Letter or A4 size, long edge feed. Tray 3 can hold 1,200 sheets
2
paper in Letter or A4 size. The Tandem Tray Module is
Machine Components
2
paper.
2
paper in sizes ranging from
Integrated Office
Finisher Center Tray
15