Snmp - Xerox WorkCentre 7132 System Administration Manual

4.
Set up the following options to be displayed in the frame.
• Port Number – Allows you to configure the port number.
• TBCP Filter (Only available when the optional PostScript Kit is installed.)
• Connection Time-Out – Allows you to specify the connection time-out period
5.
Select [Apply] to reflect the new setting.
6.
Enter the user ID and password then select [OK].
NOTE: The default user ID is "11111" and the default password is "x-admin".
7.
When the reboot message appears, select [Reboot Machine].
NOTE: For more information about the contents of items, refer to the CentreWare
Internet Services chapter of the User Guide.

SNMP

This page allows you to configure the SNMP settings for the following options.
NOTE: Some settings on this page will only be available after you restart CentreWare
Internet Services, or after the machine is switched off and on.
1.
At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2.
In the [Properties] frame, select the plus symbol [+] to the left of the [Protocol
Settings] folder.
3.
Select [SNMP].
4.
Set up the following options to be displayed in the frame.
• Community Name (Read Only) – Enter the community name used for display.
• Community Name (Read/Write) – Enter the community name for display and
• Community Name (Trap Notification) – Enter the trap notification community
• System Administrator – Enter the name of the System Administrator.
• Trap Notification Settings – Allows you to set the trap destination addresses.
Xerox WorkCentre 7132 System Administration Guide
Using CentreWare Internet Services to Configure Settings on the Machine
when transmission fails.
update.
name.
- Transport
- Network number (IPX)
- MAC address (IPX)
- Socket number (IPX)
- IP address (UDP)
- Port number (UDP)
- Trap version
- Community String (Trap Notification)
57