Xerox WorkCentre 7132 System Administration Manual page 91

Parameter
CB/cb
GC/gc
GB/gb
AC/ac
AB/ab
NOTE: If several parameters are specified in the first lpr command, data may not print.
NOTE: For some print languages, the color parameter may be invalid.
NOTE: The system default is used if no parameter is specified.
Specifying stapling
The following parameters can be specified for stapling.
STAPLETL
STAPLETD
STAPLETR
STAPLELD
STAPLERD
STAPLEBL
STAPLEBD
STAPLEBR
NOTE: If several parameters are specified in the first lpr command, data may not print.
NOTE: For some print languages, the stapling parameter may be invalid.
Printing
To specify the output format of printing, enter the following command:
Enter a "," (comma) after -C followed by the parameters which specify the output
format. To specify multiple parameters, separate them with ",".
For example, to print a file named "file1", two-sided on A4 (210 × 297 mm/8.3 × 11.7
inches) on printer fxPS, enter the following command:
Xerox WorkCentre 7132 System Administration Guide
Selects color for color mode and speed priority for print mode.
Selects monochrome for color mode and quality priority for print mode.
Selects monochrome for color mode and speed priority for print mode.
Selects auto (color/monochrome) for color mode and quality priority for
print mode.
Selects auto (color/monochrome) for color mode and speed priority for
print mode.
Parameter
-C,[parameter],[parameter]
%lpr -PfxPS -C,DUP,A4 file1
Description
Places one staple in the upper left corner of the prints.
Places two staples at the top of the prints.
Places one staple in the upper right corner of the prints.
Places two staples on the left side of the prints.
Places two staples on the right side of the prints.
Places one staple in the lower left corner of the prints.
Places two staples at the bottom of the prints.
Places one staple in the lower right corner of the prints.
Description
-C Option
91