Setting Up Distinctive Ringtone Pattern Detection - Xerox Phaser 6121MFP User Manual

Faxing

Setting Up Distinctive Ringtone Pattern Detection

If you have one line that serves as both a fax and phone line, you can configure the printer to
distinguish an incoming fax from an incoming phone call based on the ringtone pattern. When an
incoming fax is detected, the printer will process it as a fax.
Note: There are four pre-assigned ringtone patterns for fax. Which one you use depends on your
location and PBX (private branch exchange) provider. If you do not know which ringtone to use,
contact your PBX provider to determine which pattern is used for fax numbers.
To set up Distinctive Rrington Pattern Detection:
1. On the printer control panel, press the Fax button.
2. Press the Down Arrow button to go to Fax Default Setup and then press the OK button.
3. Arrow down to Receive Option and press OK.
4. Arrow down to Receive Mode and press OK.
5. Arrow down to Distinctive Ring and press OK.
6. Select the ringtone type as specified by your PBX provider:
Ring
Long-long
Short-long-short
Short-short-long
Very long (normal pattern)
7. Press OK.
126 Phaser 6121MFP Multifunction Printer
User Guide
Ring Pattern
6121-207
6121-208
6121-209
6121-210