Appendix L - Dve 50-A Probe Clip - Ametek BROOKFIELD DVNext Operation Instructions Manual

APPENDIX L - DVE 50-A PROBE CLIP

Probe Clip DVE-50A is supplied with all model DVNext Rheometers, DV-III Rheometers, and Digital Temperature
Indicators. It is used to attach the RTD temperature probe to the LV Guard Leg (Part No. B-20Y) or 600 mL low form
Griffin beaker. Figure L-1 is a view of the Probe Clip, showing the hole into which the RTD probe is inserted, and the
slot which fits onto the LV guard leg. When inserting the RTD probe into the Probe Clip, the upper part of the Clip is
compressed by squeezing the points shown in Figure L-1.
Note: All Viscometer/Rheometer models — except LV — use the Probe Clip as shown in Figure L-3.
Figure L-2 shows the Probe Clip (with RTD temperature probe installed) mounted on the LV guard leg.
Figure L-3 shows the Probe Clip mounted in a 600 mL low form Griffin beaker. This mounting may be used with LV,
RV, HA and HB series instruments.
Temperature probe must not contact the spindle during measurement.
Note:
measurement.
M19-2101 REVISION 2.0
The RTD probe must be parallel to the beaker wall so as not to interfere with the viscosity
Figure L- 2
D V N E X T R H E O M E T E R - O P E R AT I O N A L M A N U A L
Figure L- 1
Figure L- 3
147