Table of Contents
Advertisement
APPENDIX H - DVE 50-A PROBE CLIP
Probe Clip DVE-50A is supplied with all model DV series Viscometers, Rheometers, and Digital Temperature
Indicators. It is used to attach the RTD temperature probe to the LV Guard Leg (Part No. B-20Y) or 600 mL low form
Griffin beaker. Figure J-1 is a view of the Probe Clip, showing the hole into which the RTD probe is inserted, and the
slot which fits onto the LV guard leg. When inserting the RTD probe into the Probe Clip, the upper part of the Clip is
compressed by squeezing the points shown in Figure J-1.
Note: All Viscometer/Viscometer models — except LV — use the Probe Clip only as shown in Figure J-3. The Probe
clip is mounted in a 600-mL low form Griffin beaker. The geometry of the RV guard leg precludes the mounting
directly to the guard leg.
The LV uses the Probe clip (with RTD Temperature Probe installed) as shown in Figure J-2 or as shown in Figure J-3.
Temperature probe must not contact the spindle during measurement.
Note: The RTD probe must be parallel to the beaker wall so as not to interfere with the viscosity
measurement.
M21-400 REV.1.1
Figure J- 1
Figure J- 2
D V P L U S D I G I TA L V I S C O M E T E R - O P E R AT I O N A L M A N U A L
Figure J- 3
69
Advertisement
Table of Contents
