Table of Contents
Advertisement
Step 3:
•
Completely remove Tab 1 (see Figure M-3).
•
Lightly press the screen protector to the touch screen.
•
Inspect the alignment of the screen protector. If the screen
protector is touching the bezel (frame), then remove and
reapply.
Step 4:
•
Peel back Tab 2 all the way to remove the backing, which
also removes the alignment tool (see Figure M-4). The screen
protector is now in place.
Step 5:
•
Use the soft card provided to push trapped air bubbles
from the center of the screen to the edge (see Figure M-5).
Small bubbles should go away within 48 hours.
•
DO NOT use the soft card to push the screen protector
under the bezel (frame). If the screen protector is not
properly aligned, remove and reapply. Two screen protectors
are provided in this package in case the first attempt is
unsuccessful.
•
Test the viscometer (power on) to ensure that the screen
protector is properly attached. The screen protector is properly
aligned if the DVNext Rheometer responds normally to a touch
on the touch screen. If the DVNext Rheometer is unresponsive
to touch, then remove the screen protector and reapply.
Removal of the screen protector
The screen protector should be replaced when it has become dirty. It can be easily removed from the DVNext Rheometer by
hand. The upper right hand corner of the screen protector has a small angle cut. Use a finger nail or blunt object to pry the screen
protector away from the touch screen and peel it off the touch screen.
Be careful not to scratch the touch screen when removing the screen protector.
M19-2101 REVISION 2.0
D V N E X T R H E O M E T E R - O P E R AT I O N A L M A N U A L
Figure M- 3
Figure M- 4
Figure M- 5
149
Advertisement
Table of Contents
