Table of Contents
Advertisement
Hold the barcode scanner at a 20-30° downward angle, approximately 3-6 inches from the spindle (see Figure 3-22).
Aim the barcode scanner's red dot at the spindle barcode (see Figure 3-23). Squeeze the barcode scanner trigger
until it beeps and the Spindle field on the DVNext screen populates. Verify the correct Spindle number was scanned.
3.7.3 Scanning cone/plate spindles, attached to the DVNext
Plug the barcode scanner into one of the USB Ports on the back panel of the DVNext. Wait for the barcode scanner
to beep. On the Configure Viscosity Test screen, touch the Blue Arrow in the Spindle field to open Set Spindle.
Locate the barcode on the Cone/Plate Spindle (see Figure 3-24).
Hold the barcode scanner at a 0-10° angle, approximately 3-5 inches from the spindle. Aim the barcode scanners red
dot at the spindle barcode. Squeeze the barcode scanner trigger until it beeps and the Spindle field on the DVNext
screen populates (see Figure 3-25). Verify the correct spindle number was scanned.
M19-2101 REVISION 2.0
Figure 3-20
Figure 3-22
Figure 3-24
D V N E X T R H E O M E T E R - O P E R AT I O N A L M A N U A L
Figure 3-21
Figure 3-23
Figure 3-25
36
Advertisement
Table of Contents
