ENGLISH
Even though the appliance is provided with all
its safety devices, during the installation and
connection procedures it may be necessary to
supplement it with other safety devices in ac-
cordance with applicable laws.
The position of the devices is shown in the pic-
ture.
Safety thermostat: to cut off the electricity
A)
supply in case of overheating.
WARNING: Make a daily check that
the safety devices are properly installed and
in good working order.
The position of the signs provided is shown in
the picture.
Manufacturer and appliance nameplate.
A)
WARNING: read the manual carefully
B)
before carrying out any procedure.
WARNING: when washing the appli-
C)
ance, do not point pressurised water jets at
internal parts.
WARNING draws attention on compli-
D)
ance with the rules. "Install in compliance with
the applicable regulations and use in well ven-
tilated premises only".
WARNING draws the attention on
E)
compliance with the rules. "The Manufacturer
declines all liability in case of failure to com-
ply with the installation and commissioning
instructions".
WARNING: watch out for hot surfaces.
F)
CE Marking: it indicates that the equipment
G)
is compliant with all relevant laws applicable
to the product.
4
SAFETY DEVICES
SAFETY AND INFORMATION SIGNS
A
A
A
D
E
H
37M3162
L
WARNING:empty the well completely
L)
after use.
WEEE symbol: it indicates that the appli-
M)
ance is subject to specifi c waste disposal reg-
ulations.
SAFETY
C
B
F
37M3202
A
M
3386350__ut_GB_rev.1
G