Description Of Controls (0S1Cp1Ec); Switching The Appliance On And Off (0S1Cp1Ec) - Angelo Po 0S1CP1E User Manual

USE AND OPERATION
Power level knob: to adjust the heating in-
A)
tensity.
1) Off indicator
2) Power indicator
Hot water tap: to regulate the water fl ow.
B)
B

SWITCHING THE APPLIANCE ON AND OFF (0S1CP1EC)

Switching on the appliance
Connect the appliance to the mains power
1)
supply using the master switch-disconnector.
Fill the well (see page 19).
2)
NOTE: Before fi lling the tank, make
sure the drain lever is on "CLOSED".
Turn the knob (A) to 1 to turn on the heating
3)
elements at the maximum power and speed
up the boiling times. The mains light indicator
(D) goes on.
Turn the knob (A) to one of the other settings
4)
(pos.2), to adjust the heating element power
to a lower level.
Turning off the appliance
Cut off the water supply (see page 19).
1)
Turn the knob (A) to 3 to switch off the heat-
2)
ing elements. The mains indicator light (D)
goes off .
3386350__ut_GB_rev.1

DESCRIPTION OF CONTROLS (0S1CP1EC)

1
A
2
Thermostat indicator light: when on, it in-
C)
dicates that safety thermostats have tripped.
The light goes off once the appliance has
been reset.
Mains indicator light: it lights up to indicate
D)
that the power supply is on.
1
3
2
1
1
A
1 3
2
Disconnect the appliance from the mains
3)
power supply using the automatic switch-dis-
connector.
IMPORTANT: Empty the well com-
pletely after use.
ENGLISH
C
D
C
B
D
A
A
D
3
2
1
2
1 3
2
3
3
2
19