Electrical Connection - Angelo Po 0S1CP1E User Manual

HANDLING AND INSTALLATION
WARNING: The connection must be
made by authorised, skilled personnel, in
accordance with the applicable legal re-
quirements, using appropriate and speci-
fi ed materials.
The appliance is supplied with operating
voltage of 400V/3~N, or 230V/3 on request
(see wiring diagrams attached).
Specify the correct voltage for your device,
as it cannot be modifi ed after purchase.
HAZARD: Before doing any work, turn
off the general power supply.
Connect the appliance to the mains power sup-
ply as follows:
If not already in place, install an automatic
1)
switch-disconnector
ance, with the following characteristics:
– Thermal release (see table in the Annex sec-
tion for adjustment instructions).
– Magnetic circuit breaker curve B or C (IEC
60898).
– Residual current release set at 30 mA
3386350_inst_GB

ELECTRICAL CONNECTION

close to the appli-
(A)
B
C
D
Open the hatch (B).
2)
Loosen the screw to remove the drain lever
3)
(C)
Undo the screws to remove the panel
4)
Loosen the screws to remove the protection
5)
.
(E)
Connect the switch-connector (A) to the
6)
terminal board
in the fi gure and in the wiring diagram at the
end of the manual; use a cable with the fol-
lowing specifi cations:
– Weight: ≥ than H05RN-F (designation 245
IEC 57).
– Operating temperature: ≥ 70°C.
WARNING: When connecting, pay at-
tention to the neutral and earth cable con-
nection.
After completing the operation, fi t everything
7)
back in place.
E
ENGLISH
of the appliance as shown
(F)
A
F
.
(D)
11