Hazards And Safety Provisions During Assembly; Hazards And Safety Provisions During Installation And - Angelo Po 0S1CP1E User Manual

ENGLISH

HAZARDS AND SAFETY PROVISIONS DURING ASSEMBLY

When assembling the appliance, watch out for the following hazards and provide for the counter-
measures indicated below:
► Source of hazard: Handling of heavy loads
Hazard
Risk of injury due
to body overload
HAZARDS AND SAFETY PROVISIONS DURING INSTALLATION AND COMMISSIONING,
During appliance installation, commissioning, adjustment and part replacement procedures,
watch out for the following hazards and provide for the countermeasures indicated below.
► Source of hazard: Appliance mechanics
Hazard
Risk of crushing
parts of the body in
case of tip-over or
fall of the appliance
Risk of cutting due
to sharp edges
Risk of crushing
parts of the body
in case of fall of the
appliance
6
Where or in which situa-
tions does the hazard occur?
• When the appliance
moves
ADJUSTMENTS AND PART REPLACEMENT
Where or in which situa-
tions does the hazard occur?
When the appliance is
lifted
When handling sheet-met-
al parts
In case of uneven or sloped
fl oors
Countermeasures
• Use a suitable lifting de-
vice to place the appliance
on the work bench, on the
base
• Adjust the position only if
a suitable number of peo-
ple is available, otherwise
observe the limit values for
lifting and transport
• Comply with the applica-
ble laws on accident pre-
vention for the installation
place
• Wear personal protective
equipment
Countermeasures
• Pay attention to the centre
of gravity
• Avoid collisions
• Pay special care during this
activity
• Wear personal protective
equipment in accordance
with safety regulations
• Comply with the correct in-
stallation requirements as
per section "Installing the
appliance" on page 10 of
the installation manual.
SAFETY
Safety device
• P r o t e c t i v e
gloves
• P r o t e c t i v e
shoes
• Safety helmet
(e.g. for sus-
pended loads,
overhead op-
erations...)
Safety device
None
None
None
3386350__ut_GB_rev.1