Safety Devices; Safety And Information Signs - Angelo Po 0N1CP1EL User Manual

ENGLISH
Although the appliance is complete with all
safety devices, during installation and connec-
tion additional devices must be added if neces-
sary to comply with the relevant legal require-
ments.
The illustration shows the position of the de-
vices.
Safety thermostat: to cut off the electricity
A)
supply in case of overheating.
WARNING: Make a daily check that
the safety devices are properly installed and
in good working order .
The position of the signs provided is shown in
the picture.
Manufacturer and appliance nameplate .
A)
WARNING: read the manual carefully
B)
before carrying out any procedure.
WARNING: when washing the appli-
C)
ance, do not point pressurised water jets at
internal parts.
WARNING draws attention on compli-
D)
ance with the rules. "Install in compliance with
the applicable regulations and use in well ven-
tilated premises only".
WARNING draws the attention on
E)
compliance with the rules. "The Manufacturer
declines all liability in case of failure to com-
ply with the installation and commissioning
instructions".
WARNING: watch out for hot sur-
F)
faces.
CE Marking: it indicates that the equipment
G)
is compliant with all relevant laws applicable
to the product.
4

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

A
A
A
D
ПРОИЗВОДИТЕЛЬ НЕ НЕСЕТ ОТВЕТСТВЕННОСТИ ЗА КАКОЙ-ЛИБО УЩЕРБ ПРИ НЕСОБЛЮДЕНИИ ПРАВИЛ
МОНТАЖА И ЭКСПЛУАТАЦИИ
E
АППАРАТ ДОЛЖЕН УСТАНАВЛИВАТЬСЯ СОГЛАСНО ДЕЙСТВУЮЩИМ ПРАВИЛАМ И ИСПОЛЬЗОВАТЬСЯ ТОЛЬКО В
ХОРОШО ПРВЕТРИВАЕМЫХ ПОМЕЩЕНИЯХ.
G
37M3162
L
WARNING:empty the well completely
L)
after use.
WEEE symbol: it indicates that the appli-
M)
ance is subject to specific waste disposal regu-
lations.
SAFETY
C B
F
37M3202
H
A
M
3320040_ut_GB_rev.3