Installing A Wi-Fi Module - Nexcom Neu-X102 User Manual

Chapter 3: System Setup

Installing a Wi-Fi Module

1. With the chassis cover removed, locate the mini-PCIe slot on the board.
2. Tighten the bracket (506900226X00) with the Wi-Fi module using the
bundled screws (50311F0330X00,
3. Insert the Wi-Fi module into the slot at a 45 degree angle until the gold-
plated connector on the edge of the module completely disappears
inside the slot.
4. Tighten the screw (50311F0295X00) through the mounting hole on the
secured bracket to the standoff on the motherboard.
5. Attach the RF cables onto the Wi-Fi module and insert the antenna jack
end of the cables through the antenna holes. Refer to
Antennas section for more details.
Copyright © 2023 NEXCOM International Co., Ltd. All Rights Reserved.
2pcs).
Assembling the
Standoff for securing the Wi-Fi module with the bracket.
Module holes for tightening the bracket with the bundled screws.
Note that the module in this image is not screwed to the bracket.
28
Neu-X102 User Manual