Table of Contents
Advertisement
Chapter 3: System Setup
Installing a M.2 Storage Module (M2M1)
1.
Locate the M.2 2280 Key M slot (M2M1) on the motherboard and pull
out the plastic standoff.
Plastic Standoff
The plastic standoff is subject to change depending on the
packaging requirements. The installation process shown here
uses a plastic standoff but may be replaced with a screw.
Copyright © 2023 NEXCOM International Co., Ltd. All Rights Reserved.
M.2 Key E (M2M1)
35
2.
Insert the M.2 module into the M.2 slot at a 45-degree angle until
the gold-plated connector on the edge of the module completely
disappears into the slot.
3.
Push the module down and use the notch on the middle of the plastic
standoff to secure the M.2 module.
When purchasing an M.2 storage, it is recommended to use a
complementary dedicated thermal pad. Stick it to the original
set of M.2 module for a better heat dissipation.
NDiS B561S User Manual
Advertisement
Table of Contents
