132 Errors - Lexmark MX61 Series Service Manual

Action
Step 3
a
Turn off the printer.
b
Remove the power cord.
c
Measure the resistance between terminals A and D of the
power supply socket.
Is the resistance approximately 30 ohms?

132 errors

132 error messages
Error code Description
132.01 TDS baseline too low.
132.02 TDS baseline too high.
132.03 TDS baseline excessive range.
132.16 TDS calibration at maximum.
132.17 TDS calibration too low.
132.18 TDS calibration too close to baseline.
132.32 PC drum measurement too high.
132.33 PC drum measurement too different from
calibration.
132.34 PC drum measurement too close to baseline.
Toner density sensor service check
Action
Step 1
Remove the transfer roll, and then check for loose toner blocking
the toner density sensor.
Is it free of loose toner?
Step 2
Check the TDS for proper operation:
a
Lower the ACM assembly.
b
Move the toner density sensor wiper from left to right.
Does it move freely?
Action
Go to "Toner density sensor service check" on
page 138.
Diagnostic information
138
Yes No
Contact your next Replace the LVPS.
level of support. See
removal" on
page
Yes No
Go to step 2. Clean the sensor.
Go to step 3. Reinstall the wiper
properly. If it still
cannot move freely,
then replace the
toner density sensor.
See
sensor removal" on
page
7016
"Power supply
323.
"Toner density
330.