Insufficient memory service check
Action
Step 1
Disable the Resource save feature:
Settings > Print Settings > Setup Menu > Resource Save > Off
Does the problem remain?
Step 2
Check the memory card for proper installation.
Is it properly installed?
Step 3
a
Print the Menu settings page:
Settings > Reports > Menu Settings Page
b
POR into the Configuration menu and reset the printer's
settings to factory default:
Configuration Menu > Factory Defaults > Restore Base
c
Remove the memory card.
d
Restart the printer.
Does the error remain?
Imaging unit low service check
Action
Step 1
Replace the imaging unit.
Does the problem remain?
Step 2
a
Make sure the imaging unit smart chip contact cable is properly
connected to the controller board.
b
Make sure the contacts are free of debris.
Does the problem remain?
Step 3
Check the contacts for damaged pins.
Are they free of damage?
Diagnostic information
130
Yes
No
Go to step 2.
The problem is
solved.
Go to step 3.
Reseat the memory
card.
Replace the
Replace the memory
controller board. See
card.
"Controller board
removal" on
page
282.
Yes
No
Go to step 2.
The problem is
solved.
Go to step 3.
The problem is
solved.
Contact the next
Replace the printer.
level of support.
7016