9
Feed the USB cable through the channel on the left side of the printer.
USB wireless cable removal
1
Remove the right cover. See
2
Remove the controller board shield. See
3
Remove the fan.
4
Disconnect the MFP wireless cable from the RIP board.
5
Remove the scanner front cover. See
6
Remove the control panel assembly. See
7
Remove the UICC drip pan.
8
Lift the wireless control panel cover.
Note: For MX410 machines, two screws must be removed to release the toroid from the cable.
"Right cover removal" on page
"Controller board shield removal" on page
"Scanner front cover removal" on page
"Control panel assembly removal" on page
Repair information
370
277.
361.
7016
284.
298.