8
If necessary, remove the bushing (B) from the redrive assembly.
Installation note: Install the bushing (A) on the redrive assembly before installing the shaft.
Fuser removal
1
Remove the left cover. See
2
Remove the rear door and cover. See
on page
343.
3
Remove the redrive assembly. See
4
Disconnect the cable JEXIT1 from the controller board.
5
Disconnect the two cables (A).
"Left cover removal" on page
"Rear exit door removal" on page 342
"Redrive assembly removal" on page
Repair information
346
264.
and
343.
7016
"Rear cover removal"