Table of Contents
Advertisement
5
Close the finisher rear door.
6
If necessary, touch Done from the printer control panel to clear the message and continue printing.
200 paper jams
200 paper jam messages
Notes:
•
Some error messages are applicable only to printer models with installed polygon LSU (laser scanning
unit).
•
If the sixth digit character assigned to the serial number of the printer is in the P–Z range, then the
printer is installed with a polygon LSU (example: 4514 2ZHH 007CR).
Error code
Description
200.01
Input sensor covered during warm-up sequence. Go to
200.02
Input sensor covered too quickly.
200.03
Media did not reach input sensor from MPF.
200.05
Input sensor covered too long.
200.07
Input sensor failed to become uncovered from
sheet ahead.
200.08
Page arrive at input senor at unexpected time.
200.09
Printhead did not receive proper motor feedback
to start laser servo.
200.10
Printhead motor not locked when media reaches
the input sensor.
Action
on page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
on page
Go to
on page
Diagnostic information
73
"Sensor (input) static jam service check"
75.
"Sensor (input) early/late arriving service
76.
"Sensor (input) early/late arriving service
76.
"Sensor (input) early/late arriving service
76.
"Sensor (input) early/late arriving service
76.
"Sensor (input) early/late arriving service
76.
"Sensor (input) image jam service check"
77.
"Sensor (input) image jam service check"
77.
7016
Advertisement
Table of Contents
