Stapler Rear Cover Close Limit Switch Removal - Lexmark MX61 Series Service Manual

3
Disconnect the motor cable (B), and remove the tamper motor.
Warning—Potential Damage: Be careful not to lose the tamper belt when removing the tamper motor.
Installation note: Make sure to engage the motor gears with the tamper belt.

Stapler rear cover close limit switch removal

1
Remove the stapler service cover. See
2
Disconnect the limit switch cable from the controller card.
3
Remove the stapler right cover. See
"Stapler service cover removal" on page
"Stapler right cover removal" on page
Repair information
399
397.
384.
7016