Parallel port [x] disabled [56]
Try one or more of the following:
•
From the printer control panel, touch Continue to clear the message.
•
Enable the parallel port. From the printer control panel, navigate to:
Network/Ports > Parallel [x] > Parallel Buffer > Auto
Note: The printer discards any data received through the parallel port.
Printer had to restart. Last job may be incomplete.
From the printer control panel, touch Continue to clear the message and continue printing.
For more information, visit
Remove defective disk [61]
Remove and replace the defective printer hard disk.
Remove paper from standard output bin
Remove the paper stack from the standard bin.
Replace defective imaging unit [31.xy]
Replace the defective imaging unit to clear the message. For more information, see the instruction sheet
that came with the supply.
Note: If you do not have a replacement imaging unit, then see the "Ordering supplies" section of the
User's Guide or visit www.lexmark.com.
Replace cartridge, 0 estimated pages remain [88.xy]
Replace the toner cartridge. For more information, see the instruction sheet that came with the supply.
Note: If you do not have a replacement toner cartridge, then see the "Ordering supplies" section of the
User's Guide.
Replace imaging unit, 0 estimated pages remain [84.xy]
Replace the imaging unit. For more information, see the instruction sheet that came with the supply.
Replace maintenance kit, 0 estimated pages remain [80.xy]
Contact customer support at
the message. The printer is scheduled for maintenance.
http://support.lexmark.com
http://support.lexmark.com
Diagnostic information
118
or contact customer support.
or your service representative, and then report
7016