132 Errors - Lexmark MS310 4514-220 Service Manual

132 errors

132 error messages
Error code Description
132.01 TDS baseline too low.
132.02 TDS baseline too high.
132.03 TDS baseline excessive range.
132.16 TDS calibration at maximum.
132.17 TDS calibration too low.
132.18 TDS calibration too close to baseline.
132.32 PC drum measurement too high.
132.33 PC drum measurement too different from
calibration.
132.34 PC drum measurement too close to baseline.
Toner density sensor service check
Action
Step 1
Remove the transfer roll, and check for loose toner blocking the
toner density sensor.
Is it free of loose toner?
Step 2
Check the toner density sensor for proper operation:
a
Lower the ACM assembly.
b
Move the toner density sensor wiper from left to right.
Does it move freely?
Step 3
Check the toner density sensor cable for proper connection to the
controller board.
Is it properly connected?
Step 4
Check the toner density sensor cable for damage and pinch points.
Is it free of damage?
Action
Go to
page
Diagnostics and troubleshooting
130
"Toner density sensor service check" on
130.
Yes No
Go to step 2. Clean the sensor.
Go to step 3. Reinstall the wiper
properly. If it still
cannot move freely,
replace the toner
density sensor. See
"Toner density
sensor removal" on
page
Go to step 4. Reseat the cable.
Replace the Replace the toner
controller board. See density sensor. See
"Controller board "Toner density
removal" on sensor removal" on
page 210. page
4514-2xx
244.
244.