Table of Contents
Advertisement
Error code
Description
200.44
Page from Tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple
pick attempts. Page did make it out of the tray at
least as far as the ACM sensor.
200.45
During warm up flush, sheet detected too long
over input sensor.
Sensor (input) static jam service check
Action
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Step 2
Check the jam access cover if it is blocking the input sensor.
Is it blocking the input sensor?
Step 3
Check the input sensor cable for proper connection.
Is it properly connected?
Step 4
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Input.
Does the sensor state on the control panel display change when
it is toggled?
Step 5
Does the error remain?
Action
Go to
check" on page
Go to
check" on page
Diagnostic information
75
"Sensor (input) early/late arriving service
76.
"Sensor (input) early/late arriving service
76.
Yes
No
Go to step 2.
Clear the paper path
of any media
fragments.
Replace the jam
Go to step 3.
access cover. See
"Jam access cover
removal" on
page
315.
Go to step 4.
Reseat the cable.
Go to step 5.
Replace the input
sensor. See
sensor and input
sensor removal" on
page
Contact the next
The problem is
level of support.
solved.
7016
"Duplex
325.
Advertisement
Table of Contents
