Selecting 900Ae/Ao Configure Settings - Branson 900M Series Manual

4.
Selecting 900AE/AO Configure Settings
This sub-menu allows you to configure your 900M/900AE/AO welding system.
Settings Choices
Function
Language = ENGLISH (D)
DEUTSCH
FRANCAIS
CASTELLANO
ITALIAN°
Select the language in which you wish
information to be displayed.
UNITS = USCS (D) Select standard American units to measure and
display all settings and date.
METRIC / SI Select metric units to measure and display all
settings and date.
ULS ACTIVE = HI / OPEN (D) Select the
ULS
signal to become active when the
signal goes high (+24VDC).
LO / CLOSED Select the us signal to become active when the
signal goes low (OV).
If you selected PTS ON in sub-menu 1. Trigger/Actuator, move to the next setting
(PRETRIGGER). If you selected PTS OFF, skip the next setting and move to
TRS ACTIVE = .
Note: If you start weld timing on the
PIS
signal, stroke or down speed variation adds
an unpredictable error into the weld time. This happens because some of the
timing occurs during the actuator's stroke, before the part is contacted. The
shorter the weld cycle/longer the stroke length, the more significant the error.
Therefore the preferred selection is ms.
900M P/S Operator's
4-33 Operation