After entering the Limits/Power sub-menu, set Peak Power as follows:
Setting
Choices
Function
PK POW END WLD
OFF (D)
Do not select peak power input to end the weld
and proceed to hold.
ON
Select peak power input to end the weld and
proceed to hold.
PEAK POWER =
1-110 %
(D=1%)
Select the value of peak power used to end the
weld and proceed to hold.
g. Distance Mode Settings
This mode is used in conjunction with a 900AES/AOS actuator and is set through the
Setup menu, 1. Distance Mode sub-menu.
This mode allows you to further define your weld cycle with distance settings.
Operation
4-26
900M P/S Operator's