Weld System Settings; How To Access And Leave The Setup Menus; How To Move Around Within The Sub-Menus - Branson 900M Series Manual

X
4.4
Weld System Settings/Menus
Weld system parameters on the 900M and 900AE/AO and 900AES/AOS Actuators can be
set or changed using Setup and Printer menus, depending on the actuator you install. To
use the Printer Menu you must have an External Communications Interface (ECI-1).
Instructions for using the Printer Menu can be found in the External Communications
Interface (ECI-1) Instruction Manual.
The weld system settings in the Setup menus allow you to add monitored levels of
control to your weld cycle.
4.4.1
How to access and leave the Setup Menus
Access and leave the Setup Menus as follows:
Press this key This happens
1. SETUP
When the 900M is in
READY
state, this puts you into the Setup menus.
2. PRINT
Brings you to the sub-menu level.
3. PRINT
again Moves you from sub-menu to sub-menu.
4. sErtm,
Takes you out of Setup menus and back to your previously selected
weld mode.
4.4.2
How to move around within the sub
-
menus
a. Moving from setting to setting
Once you have selected a sub-menu by pressing
PRINT,
press the double
UP
and
DOWN
arrow keys to move forwards and backwards from setting to setting through the sub-
menus.
b. Making choices within a setting
1. Changing numeric choices
If you want to set or change a numeric choice, the middle sar.cr switch
LED
blinks. To
change the numeric choice's value:
Press this key To do this
Middle sFlEcr Select the choice for modification. The sFiEcr switch
LED
will
turn on and three clashes will be displayed.
Fast or Slow
UP/DOWN
Display the value you want to set in the
STATUS
display.
Middle
SELECT
Return to the Setup menus. The switch LED will resume
blinking.
900M P/S Operator's
4
-
27
Operation