Setting Time Mode - Branson 900M Series Manual

Setting
TIME
Mode
The following table describes how to make settings the first time you use this mode.
Please note that once you select settings, the digits you see in the display windows will
differ from the default values shown here.
Once you have set the desired value, press
TIME
to reenter "READY TIME MODE IX".
Press this key
This happens
On the
STATUS
display,
you see
1. TIME
You access
TIME
mode "READY TIME MODE 1X"
2. Top suEcr You access
TIME
settings "WELD TIME /mSEC"
3. Top suEcr again
You access the minimum setting "050"
"WELD TIME /mSEC"
4. Top
SELECT
again You access 25% of the maximum
setting
"2.50"
"WELD TIME /SECONDS"
5. Top
SELECT
again You access the minimum setting "050"
"WELD TIME /mSEC"
6. UP/DOWN
arrows You change settings by 005/025
msec increments
For example, "075" msec
"WELD TIME /mSEC"
7. TIME or SELECT
The unit retums to
READY
state
"READY TIME MODE 1X"
There are two ways to exit from weld modes:
1. Press the flashing mode key or keys.
2. After pressing any
UP / DOWN
arrow key(s), press the appropriate
SELECT
key.
Storing Settings: After fine-tuning all your welding settings, you can store them in
memory as a preset for recall at a later date. (See instructions for storing and recalling
weld settings in Section 4.6.) Once you have performed a weld cycle or activated a
PALM
BUTTON,
the current weld settings are automatically stored in preset 0. You can store up
to 20 presets.
900M P/S Operator's
4-7
Operation