4.6.8 Manual Tuning
If you have changed a converter, booster or horn stack component, you must manually
tune the system. Use the procedure outlined in Figure 4-12 "Manual Tuning Flow Chart"
If, after using the chart, your system repeatedly overloads:
•
inspect stack components for failure (wear, cracks, etc.);
•
inspect mating surfaces of stack components;
•
ensure that stack components are tightened properly; and
•
ensure correct line voltage/tap settings.
If these measures do not solve the problem, refer to the 900M Series Power Supplies
Maintenance Manual, contact your local Branson representative, or call Branson's
Product Support Department.
Operation
4-68
900M P/S Operator's