Table of Contents
Advertisement
12. OPERATION OF EACH SPECIAL MODULE MONITOR SCREEN
12.1.6 Changing the screen
(∗1)
This section describes how to change the screen when executing each monitor
function of the special module monitor function from the status where the user-created
monitor screen is displayed.
Start
User-created monitor screen
Touch
(∗1)
Utility screen
Touch
Touch
END
System Configuration screen
(See Sec. 12.1.1.)
Touch
Touch on display module.
sys.conf.
When I/O module is selected
1)
When special function
module is selected
Monitor menu display screen
for specified module
(See Sec. 12.1.4.)
Touch END
Go to user-created monitor screen
or utility screen.
∗1
Touch the key where the touch switch (expanded)
function was set with the drawing software, and start
the special module monitor operation.
When the Utility screen is displayed, touch SP.UNIT
and start the special module monitor function.
The system monitor function and special module monitor
!!!!!!!!!
function can also be started from the Utility menu screen.
SP.UNIT
Touch on
monitor menu.
Touch
MONIT MENU
1)
12 - 7
MELSEC
Key window display screen
for test
(See Sec. 12.1.5.)
Touch DataChg.
Touch
and SET/RESET
Monitor screen for specified
monitor menu
(See Sec. 12.1.2.)
GOT
Advertisement
Table of Contents
