Table of Contents
Advertisement
12. OPERATION OF EACH SPECIAL MODULE MONITOR SCREEN
12.22.3 Parameter data monitor
1)
No.
The ON/OFF status of the I/O signal corresponding to the PLC CPU is
1)
displayed. The I/O signal is ON when displayed in a reverse display.
2)
The set manual pulser run enabled/disabled status is displayed.
3)
The set value of the travel distance per 1 pulse is displayed.
The set value of the travel distance per 1 pulse using the manual pulser is
4)
displayed.
5)
The set value of the speed limit is displayed.
6)
The set value of the jog speed limit is displayed.
7)
The set value of the acceleration/deceleration time is displayed.
8)
The set value of the backlash compensation amount is displayed.
9)
The set value of the upper stroke limit is displayed.
10) The set value of the lower stroke limit is displayed.
11) The set value of the error compensation amount is displayed.
12) The set value of the starting bias speed is displayed.
13) The set value of the positioning complete signal output time is displayed.
14) The set value of the M code is displayed. 0: M code not used
15) The error code is displayed when an error occurs.
16) The set status of the parameter data is displayed.
4)
11)
2)
Contents of display
12 - 76
3)
5)
6)
7)
8)
9)
10)
12)
13)
14)
15)
GOT
MELSEC
Buffer memory address
to reference (decimal)
X axis
Y axis
47
347
7873
7893
7884
7904
7885
7905
7874
7894
7875
7895
7876
7896
7877
7897
7878
7898
7879
7899
7880
7900
7881
7901
7882
7902
7883
7903
7886
7906
7887
7907
46
346
45
345
7872
7892
16)
16)
Advertisement
Table of Contents
