Pulsegenerator - IAI SW-4000TL-10GE User Manual

SW-4000TL-10GE | SW-4000TL-SFP | User Manual (2.0)

PulseGenerator

Configure pulse generator settings.
Pulse Generator Item
ClockPreScaler
PulseGeneratorClock (MHz)
PulseGeneratorSelector
PulseGeneratorLength
Value
PulseGeneratorLength(ms)
PulseGeneratorFrequency
(Hz)
PulseGeneratorStartPoint
Value
PulseGeneratorStartPoint
(ms)
PulseGeneratorEndPoint
Value
PulseGeneratorEndPoint
(ms)
PulseGeneratorPulseWidth
(ms)
PulseGeneratorRepeat
Count
Setting Range Default
1 ~ 4096 1
- 100
PulseGenerator0
PulseGenerator1
PulseGenerator0 Select the pulse generator.
PulseGenerator2
PulseGenerator3
1 ~ 1048575 30000
- 0.3
0 ~ 1048574 3333.3333
0 ~ 1048575 0
- 0
1 ~ 1048575 15000
- 0.15
- 0.15
0 ~ 255 0
Setting List (Feature Properties)
Set the division value for the prescaler (12 bit) using
PixelClock as the base clock.
Set the clock used for the pulse generator. This value is
calculated using the [ClockPreScaler] value as a base.
PulseGeneratorClock = 100 / ClockPreScaler
Set the maximum count-up value as a clock count.
Set the maximum count-up value in milliseconds.
PulseGeneratorLength = 1/PulseGeneratorClock *
PulseGeneratorLengthValue
Set the maximum count-up value as a frequency.
PulseGeneratorFrequency = 1sec / PulseGeneratorLength
Set the start point of the High interval as a clock count.
When the counter reaches this value, the output will be 1.
Set the start point of the High interval in milliseconds. When
the counter reaches this value, the output will be 1.
PulseGeneratorStartPoint = 1/PulseGeneratorClock *
PulseGeneratorStartPointValue
Set the start point of the Low interval as a clock count.
When the counter reaches this value, the output will be 0.
Set the start point of the Low interval in milliseconds. When
the counter reaches this value, the output will be 0.
PulseGeneratorEndPoint = 1/PulseGeneratorClock *
PulseGeneratorEndPointValue
Display the High interval width of the pulse in milliseconds.
The duration between the Start Point and End Point is
calculated.
PulseGeneratorPulseWidth = 1/PulseGeneratorClock *
(PulseGeneratorEndPointValue -
PulseGeneratorStartPointValue)
Set the repeat count for the counter. When this is set to 0, a
free counter is enabled with no repeat limit.
- 92 -
Description