Shading - IAI SW-4000TL-10GE User Manual

SW-4000TL-10GE | SW-4000TL-SFP | User Manual (2.0)
Pulse Generator Item
PulseGeneratorClear
Activation
PulseGeneratorClear
Source
PulseGeneratorClear
SyncMode

Shading

Configure shading correction settings.
Related Topic: Shading Correction
Shading Control Item
ShadingCorrectionMode
ShadingMode
CalibrateShadingCorrection
ShadingCalibrationResult
Setting Range Default
Off
Rising Edge
Falling Edge Off
Level High
Level Low
ExposureActive
LVAL
PulseGenerator0
~ 3*
UserOutput0 ~ 3
Line4: TTL In1
Line4: TTL In1
Line5: Opt In1
Line10: TTL In2
Logic Block0 ~ 1
EncoderTriger
Async Mode
Async Mode
Sync Mode
Setting Range Default
0: Flat Shading 0: Flat
Shading
1: Color Shading
0: Off
1: User1
0: Off
2: User2
3: User3
- -
- Idle
Setting List (Feature Properties)
Set the clear signal condition for the count clear input of the
pulse generator.
Select the count clear input signal source.
Note: *Disabled if the PulseGenerator is selected in
PulseGeneratorSelector.
Select the sync mode for the count clear input signal.
Select the shading correction method.
Set the area to which to save shading correction data. When
this is set to Off, PerformShadingCalibration will not be
executed.
Execute shading correction.
Note: This command cannot be executed under the following
conditions: when outputting no image, when outputting
TestPattern.Width and/or Height are less than 128, when
Shading Mode is Off.
Display the shading correction results.
Idle
Succeed
Error1 - Image was too bright
Error2 - Image was too dark
Error3 - Could not calibrated
- 93 -
Description
Description