⑦ Sfp+ Module (Sw-4000Tl-Sfp); ⑧ Fiber Optic Cable (Sw-4000Tl-Sfp); Step 3: Verify Camera Operation - IAI SW-4000TL-10GE User Manual

SW-4000TL-10GE | SW-4000TL-SFP | User Manual (2.0)
⑦ SFP+ Module (SW-4000TL-SFP)
Check the operation manual of the SFP+ module to be used, and attach it or remove it from the
camera. The SFP+ module can be attached to and removed from the camera only when the
camera is turned off.
Cautions:
Many SFP+ modules and fiber optic cables are Class 1 laser products. Do not look into
l
connectors and cables when installing or removing. There is a risk of injury to eyes.
Do not exceed the operational temperature of SW-4000TL-SFP and SFP+ module.
l
⑧ Fiber Optic Cable (SW-4000TL-SFP)
The longest cable length varies depending on the type of 10GBASE-R standard and SFP+
module. Below shows the relationship between fiber optic cable type and 10GBASE-R standard.
Correctly select the fiber optic cable type according to the 10GBASE-R standard and SFP+
module to be used.
Maximum Fiber Optic Cable Length
10GBase-SR : 300m (Fiber optic cable type OM3), 400m (Fiber optic cable type OM4)
l
10GBase-LR : 10km (Fiber optic cable type OS2)
l
10GBase-ER : 40km (Fiber optic cable type OS2)
l

Step 3: Verify Camera Operation

When power is supplied to the camera while the necessary equipment is connected, the
POWER/TRIG LED at the rear of the camera lights amber, and initialization of the camera starts.
When initialization is complete, the POWER/TRIG LED lights green.
Verify whether power is being supplied to the camera by checking the rear LED. When properly
turned on, the power LED is lit green.
For details on how to read the LEDs, see the ② POWER/TRIG LED
- 23 -
Preparation
section.