Table of Contents
Advertisement
Models 9590 & HD9590 Graticule Generator Manual
3.3.3. Controlling the Object Attributes
The CTRL SEL button is used to select which object attributes (white level, size, position, etc) will be
adjusted using the shaft encoder knobs. The particular items available in the CTRL SEL menu are
determined by settings in the SETUP menu and the object MODES in force at the time.
Sections 3.4 to 3.8 give a complete description of how to control each of the individual objects. In the
sections describing the CTRL SEL items, the relevant settings from the MODE and SETUP menus are
shown where necessary.
3.3.4. Front Panel Display when Controlling the Objects
When an object is selected the name of the selected object will appear on the display. After a 3-second
timeout, the display will show the current value of the object parameters being controlled by the knobs (as
determined by the CTRL SEL menu). If all of the parameters cannot be displayed at the same time, the
display will cycle through the parameters.
When the object is turned off by pressing the ON/OFF key, the Front display will show that the object is
turned off. If the object is subsequently turned on, the front panel will indicate that it is on, then will show
the object parameters after a 3-second timeout.
When object attributes are being modified by turning one of the shaft encoders, the attribute being
controlled is displayed along with its current value. If there are more parameters to be displayed, the
display will cycle through the remaining parameters after a 3-second timeout.
3.4. CONTROLLING THE GRID OBJECT
The grid object consists of two horizontal lines and two vertical lines that intersect the horizontal lines.
3.4.1. Turning the Grid Object On and Off
To turn on the grid object press the GRID
button. The grid object will blink momentarily (if the obj blink
item on the setup menu is enabled), and the grid will be turned on. The LED above the GRID
button
will come on indicating that the grid object is selected. To turn off the grid object, press the ON/OFF
button when the LED is illuminated.
3.4.2. Controlling the Grid Modes
When the grid object is selected the MODE button is used to control whether it is centred or not. Press
the MODE button until the desired mode item is shown on the front panel, along with the current setting.
To select one of the other choices for that mode item, turn one of the shaft encoders knobs. When you
have chosen the desired setting for the mode item press the MODE button again to save the new setting
and view the next mode item.
Continue pressing the MODE key until you see the message Mode
Select Off. The shaft encoders revert to controlling the selected attribute for the grid.
Page 3-12
RACK MOUNT PANEL OPERATION
Advertisement
Table of Contents
