CYBEX 525T Service Manual page 57

3.
Press the UP
Total number of errors will be displayed.
If three dashes - - - are shown, the error log is empty.
4.
Press ENTER
When viewing error log use the ENTER
then back to error number. To reset the error log press the Display option
Error code list
Error Code Description
Error 1 Drive did not start (No Speed at Startup)
Error 2 GFX Communications issue
Error 3 Speed Irregularity / Underspeed
Error 4 Upper Display Communications issue
Error 5 Drive Communication Issue
Error 6 Membrane Fault (stuck key)
Error 7 Controller Over-Current (Fold-back)
Error 8 Approaching Over-Temperature
Error 9 MCC Watchdog Triggered
Error 12 Graphics Board Watchdog Triggered
Error 13 Upper Display watchdog Triggered
Error 14 Drive Error Unknown
Error 15 Embedded A/V Device Failure
Error 16 Membrane Fault (No Membrane)
Error 18 Membrane Fault - Stuck Thumb Control
Error 19 Drive Enable Line is open
Error 92 Over Current (Output)
Error 93 Over Voltage (DC Link)
Error 94 Over Heat (Heatsink)
Error 95 Low Voltage (DC Link)
Error 96 Thermal Integrator of output current
Error 98 Display Communication Lost – Belt speed zero
Cybex 525T Treadmill Part Number
or DOWN keys until Error Log is displayed.
and use the UP or DOWN keys to scroll through the error log.
key to toggle display to Time Stored, Date stored,
Page 57 of 199
key twice.