CYBEX 525T Service Manual page 178

Install incline motor
1. Place the elevation motor in position on the treadmill.
2. Install one retaining ring on the motor mount shaft and one on the tube nut shaft.
3. Apply white lithium grease to the motor mount and tube nut shafts.
4. Slide the motor mount shaft into the frame mounts and elevation motor.
5. Slide the tube nut shaft into the tube nut mounts and tube nut.
6. Install retaining rings to secure the motor mount and tube nut shafts.
Test elevation motor
1. Plug the power cord into the power outlet.
2. Start the treadmill in Manual Mode and raise the elevation until the 4" (10 cm) blocks can be removed.
3. Remove the 4" (10 cm) blocks.
4. Lower the elevation to zero percent.
5. Unplug the power cord from the power outlet.
Cybex 525T Treadmill Part Number
Item
Page 178 of 199
Description
1 Retaining ring
2 Tube nut shaft
3 Tube nut
4 Tube nut mounts
5 Motor mount shaft
6 Sleeve
7 Elevation motor
8 Frame mounts
Qty.
4
1
1
1
1
1
1
1