CYBEX 525T Service Manual page 167

2. Connect the two white fast-on connectors to the on/off switch.
3. Connect the two black fast-on connectors to the on/off switch.
4. Connect the brown and blue fast-on connectors to the on/off switch.
Install motor cover
1. Place the motor cover into position vertically by aligning the two tabs and four plastic connectors.
Two plastic connectors are mounted in the front cover and two in the motor cover. If motor cover
top does not fit properly, loosen the side screws as needed.
2. Tighten the two front cover screws using a Phillips screwdriver.
Be sure the screws are securing the motor cover's tabs.
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
Cybex 525T Treadmill Part Number
Item
Item
Page 167 of 199
Description
1 To power inlet (White)
2 To power inlet (Black)
3 On/Off switch
4 To line filter (Black)
5 To power supply (Brown)
6 To power supply (Blue)
7 To line filter (White)
Position On/Off switch as
8
shown
Description
1 Motor Cover
2 Front Cover
3 Screws
4 Plastic Connectors
Qty.
1
1
1
1
1
1
1
1
Qty.
1
1
2
4