CYBEX 525T Service Manual page 85

Error 92: Over Current (Output)
Cause:
The drive has several overcurrent situations that can cause this:
• >25A Instantly
• >200% Rated for 3 seconds (roughly 16A)
• >150% Rated for 1 minute (roughly 12A)
• >Rated for a thermal integrator, calculated time (variable) – (roughly =>8.1A)
Service:
• Verify line voltage isn't sagging.
• Check the belt/deck for wear.
• Check treadmill for physical obstructions, seized bearings, etc.
• Investigate actual line current with various weight users. Determine user weight, speed and incline
when error occurred.
• If the belt is sluggish to start, can be push-started in reverse, or the motor howls, the motor has a
phase out and requires replacing the motor.
NOTE: If the error codes have been cleared and an error 92 comes back immediately there may
be a hard set error 92. Try swapping the drive controller to another unit and verify if the error
follows. If this is the case, the drive controller would have to be replaced.
Cybex 525T Treadmill Part Number
Page 85 of 199