CYBEX 525T Service Manual page 100

4. Tilt console assembly forward and insert USB stick into the internal USB port of the MCC board.
Do NOT insert USB stick into optional E3 View Monitor.
5. Toggle power switch on (I).
The software will load into console. This procedure will take approximately 3 minutes. During this
time there will be beeping noises from the console. When upload is complete, the display will show
[re][bot].
6. Toggle power switch off (0).
7. Remove USB stick from internal USB port.
8. Install the four short screws and one long screw securing the front cover and iPad clip to the console
assembly using a Phillips screwdriver.
Complete update
1. Verify the power cord is not being pinched under the front of the treadmill.
2. Toggle power switch on (I).
3. Operate unit at all levels to verify proper operation.
Cybex 525T Treadmill Part Number
Console damage may occur. Do NOT turn power off, press any keys, or
remove USB stick during this procedure.
Page 100 of 199
Item Description
1 Console assembly
2 MCC board
Item Description
1 Console assembly
2 Short screw
3 iPad clip
4 Long screw
Qty.
1
1
Qty.
1
4
1
1