CYBEX 525T Service Manual page 43

5. Press the PGM button until LED's light up in the pattern that corresponds with your Set Top Box:
LED Auto Learned
name Learn Preset
Mode
power
learn
pro-
grammed
error
6. When done, press and hold the PGM button until the red LED lights, then release. All LED's should
blink once as confirmation this configuration is now stored.
If none of the pre-configured codes above work with your Set Top Box, the MYE CableSAT Command
Receiver can be programed as a learning remote using the Infrared Remote Control provided with your
STB. Perform the following procedure MYE CableSAT Commander Receiver Auto Learn.
MYE CableSAT Commander Receiver Auto Learn
1. Start with MYE CableSAT Command Receiver power disconnected.
2. Using a pen or paperclip, press PGM switch and hold it pressed.
3. Connect power to MYE CableSAT Command Receiver.
4. Continue to hold PGM switch until power and learn LED's are lit solid (the first two LED's) then
release.
5. Point remote control at red IR window on the side of the MYE CableSAT Command Receiver and
press Channel Up key on remote control. The learn LED will flicker and the programmed LED will
briefly light solid once command has been learned. Wait for learn LED to be solid.
6. Press Channel Down key on remote control. The learn LED will flicker and programmed LED will
briefly light solid once the command has been learned. All LED's should blink once as confirmation.
E3 View Monitor Setup
E3 View Monitor Controls
The remote control is used to perform all setup operations for the E3 View Monitor.
Cybex 525T Treadmill Part Number
AT&T, Com- Direct
Uverse cast TV
Page 43 of 199
Verizon, Time DISH
Charter Warner,
(Arris) COX,
WOW
COX Mi-
ni Box