CYBEX 525T Service Manual page 176

2. Remove motor cover by carefully lifting vertically. Do not break the four plastic connectors.
Disconnect incline motor cable
1. Remove the ground wire screw securing the ground wire using a Phillips screwdriver.
2. Disconnect the incline motor cable by un-latching the connector from the motor controller connector.
Remove elevation motor
Older models use bolts, sleeves, and nuts to secure the tube nut. If used, these will be discarded and
replaced with shafts and retaining rings. Use a 9/16" Open end wrench and a 9/16" socket wrench for
removal.
1. Remove a retaining ring from the tube nut shaft using a flat head screwdriver.
2. Slide the shaft out of the tube nut mounts.
3. Remove a retaining ring from the motor mount shaft using a flat head screwdriver.
Hold the motor while you remove the shaft so that the motor doesn't fall.
Cybex 525T Treadmill Part Number
Item
Item
Page 176 of 199
Description
1 Motor Controller Connector
2 Incline Motor Cable
3 Ground Wire Screw
4 Ground Wire
Description
1 Retaining ring
2 Tube nut shaft
3 Tube nut
4 Tube nut mounts
5 Motor mount shaft
6 Sleeve
7 Elevation motor
8 Frame mounts
Qty.
1
1
1
1
Qty.
4
1
1
1
1
1
1
1