CYBEX 525T Service Manual page 103

3. Align the top step to be centered between the hood cover support and end cap.
The gaps should be equal.
4. Tighten the five screws to 28 in-lbs (3.16 Nm) using a torque screwdriver.
5. Install the five screw covers to the top step.
6. Repeat steps for the left top step.
Complete Installation
Operate the unit at all levels to verify proper operation.
Top Steps
Tools Required:
• Phillips screwdriver
• Flat head screwdriver
Disconnect power source
1. Toggle the on/off (I/O) power switch to the off (O) position. The on/off (I/O) power switch is located
under the front end of the unit, or on the front right side panel.
2. Unplug the treadmill from the power outlet.
Cybex 525T Treadmill Part Number
Do not use power toolsThe deck holes will strip out if over tightened.
Shock and electrocution hazard.
• Unplug unit and let sit 10 minutes before cleaning or performing
maintenance.
• Electrical charge can remain in unit after unplugging.
• Keep water and liquids away from electrical parts.
Page 103 of 199
Item Description
1 Motor cover support
2 Gaps
3 Top step
4 End cap
Qty.
1
1
1
1