TransAct Ithaca 90PLUS Series Programmer's Manual page 85

Programmer's Guide
Function
ASCII
Hexadecimal
Decimal
IPCL
Return
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
11/07/05
PcOS Series 90PLUS
MICR transport request
[ESC] mT
1BH 6DH 54H
<27> <109> <84>
&%MT
none
The [ESC] mT command asks the printer to load a document for printing. The
document is fed through the reader but not read. The document is then
positioned to the top of the form.
Set MICR start delay set
[ESC] [EM] M <n>
1BH 19H 4DH <n>
<27> <25> <77> <n>
&%ZM <m >
1
none
The [ESC] [EM] M <n> command adjusts the delay from when the MICR
document sensor sees the document until the transport is started. The command
allows time for the operator to align the document before the reader clamps it.
The default is 150 milliseconds.
Where <n>: 0
1
2
7
MICR read cancel
[ENQ] <12>
05H 0CH
<5> <12>
none
The [ENQ] <12> command is a real-time command that forces a MICR read
command to stop and return no data. The command can be used to get the printer
out of a read command. It has no other effect on the printer and is always
acknowledged. (See another ENQ command for a description). If the read is
complete before the ENQ <12> is issued, the read command will operate
normally.
Set MICR translation table
[ESC] mX <n > <m > <n > <m
1 1 2
1BH 6DH 58H <n > <m > <n
1 1
<27> <109> <88> <n > <m
1
none
The command sets the MICR translation characters. If no translation is specified,
the symbols shown in the table below are used. The command does not save the
table to the configuration EEPROM.
Where: n = the ID
m = the character to translate to
Rev Q
Printer Control Codes
0 ms
100 ms
200 ms, and so on until
700 ms
> ... <n > <m > <0>
2 i i
> <m > ... <n > <m > <0>
2 2 i i
> <n > <m > ... <n > <m
1 2 2 i i
MICR Reader
> <0>
Page 73