TransAct Ithaca 90PLUS Series Programmer's Manual page 131

Programmer's Guide
Cash drawer
time
M50
compatibility
Reverse cash
drawers
Print zone
Reset inhibit
Print
suppress and
pass-through
Graphic-save
Lock
Print illegal
Commands
Line spacing
11/07/05
PcOS Series 90PLUS
The amount of time the cash drawer is energized is
adjustable from 25 to 250 milliseconds. This value will be
dependent on the cash drawer being used; however, 150
milliseconds work with most drawers.
25 to 250 milliseconds (50 milliseconds resolution)
The Series 50 Printer uses several commands that are not
supported by the Series 90PLUS Printer. These commands
(in some cases) have different functions in the Series
90PLUS Printer. If the Series 50 compatibility commands
are activated, the overlapping Series 90PLUS commands
will be deactivated.
Off
On
The designation of the cash drawers can be reversed.
Normal
Reversed
There are two print zone settings.
Normal 2.8 inches
Narrow 2.4 inches
The reset commands can be prevented from being acted
on. If reset inhibit is set to "on," the command will have no
effect. (This does not effect the parallel port INIT signal).
Off
On
There is a print suppress feature that can be off, on, or
pass-through. How this feature is setup will determine the
operation of the print suppress command. If the print
suppress command is set to off, the command will be
ignored. If the command is on, print suppress will be active.
If pass is selected, the command and data pass-through will
be active.
Off
Suppress
Pass-through
Off
On
No
Yes
Vertical Control
The line spacing can be defaulted to 6 or 8 lines per inch
(lpi).
6 lpi
8 lpi
Rev Q
Product Self Tests
Recommendation
150 ms
Page 119