TransAct Ithaca 90PLUS Series Programmer's Manual page 105

Programmer's Guide
Command
[ESC] <
[ESC] = <n>
[ESC] ? <n>
[ESC] 0
[ESC] 1
[ESC] 2
[ESC] 3 <n>
[ESC] 4
[ESC] 5
[ESC] <
[ESC] =
[ESC] ?
[ESC] @
[ESC] C <n>
[ESC] D <n > <n
1
<n > 0
i
[ESC] E <n>
[ESC] G <n>
[ESC] J <n>
[ESC] K <n>
[ESC] L
[ESC] M
[ESC] P
[ESC] Q <n>
[ESC] R <n>
[ESC] T <n>
[ESC] U <n>
[ESC] V <n>
[ESC] W ...
[ESC] [ <m><n>
[ESC] \ <nL> <nH>
[ESC] ^ ...
[ESC] a <n>
[ESC] b <n>
[ESC] c <m> <n>
[ESC] d <n>
[ESC] f <t1> <t2>
[ESC] g <n>
11/07/05
PcOS Series 90PLUS
Description
Set return home.
Select peripheral device (pass-through).
Cancel user defined characters.
Set eight lines per inch spacing.
Set 7/72-inch spacing.
Set six lines per inch spacing.
Set line spacing.
Set italic mode.
Reset italic mode.
Print one-line unidirectional (similar to EPOS).
Select peripheral device.
Cancel user defined characters.
Initialize printer.
Set form length (similar to EPOS).
> <n > ... Set horizontal tab stops.
2 3
Turn emphasize mode ON/OFF.
Turn double-strike mode ON/OFF.
Print and feed.
Print and reverse feed.
Select page mode (sets top of page for [FF]
command).
Set 12 cpi character spacing.
Set 10 cpi character spacing.
Set right margin in characters.
Select International Character Set.
Select print direction.
Turn unidirectional print ON/OFF.
Turn rotate clockwise mode ON/OFF.
Set printing area in page mode.
Select code page/print feature (same as normal
mode).
Set relative print position.
Set Epson 9-pin bit image.
Set left, center, and right justify.
Print bar code (same as normal mode).
Select station.
Feed <n> lines.
Set wait time.
Start graphic save (same as normal mode).
Rev Q
Printer Control Codes
EPOS Codes
Comment
Not necessary
Not the same
Not implemented
Extension
Extension
Ignored
Extension
Not implemented
Not implemented
Extended
Similar
Similar
Not implemented
Similar
Similar
Extension
Page 93