Validation Forms Sensing; Inserted Forms Printing; Figure 10 Inserted Slip Using Normal And Narrow Print Zone - TransAct Ithaca 90PLUS Series Programmer's Manual

General Specifications
3.6.2.2
The printer has a sensor that is used to detect the presence of a validation form. This sensor may be
queried by an application to check on the presence of a form. It is located approximately 0.5 inch (12.7
mm) below the print line and to the far right of the paper path.
3.6.3

Inserted Forms Printing

Top of form to top of print line
Minimum form length
Minimum form width
Bottom of form to bottom wire
(61.0/71.1 mm)
(63.5 - 228.6 mm)

Figure 10 Inserted slip using normal and narrow print zone

Page 14
PcOS Series 90PLUS

Validation Forms Sensing

0.06 inch (1.52 mm)
3.375 inches (85.7 mm)
2.5 inches (63.5 mm)
0.625 inch (15.9 mm)
0.50" (12.7 mm)
0.06"
(1.52 mm)
0.625" (15.9 mm)
2.40"/2.80"
2.50 - 9.00"
3.375 - 11.00"
(85.7 - 279.4 mm)
Rev Q
Programmer's Guide
11/07/05