TransAct Ithaca 90PLUS Series Programmer's Manual page 66

Printer Control Codes
Graphic Mode
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Note
Page 54
PcOS Series 90PLUS
Stop graphic-save record and save as a start-up macro
[ESC] g <7>
1BH 67H 07H
<27> <103> <7>
none
[ESC] g <7>
The [ESC] g <7> command stops recording graphic-save information and
flags it as a start-up macro. The buffer is saved into nonvolatile memory.
The printer will remain busy for about seven seconds after the command to
erase and resave the graphic-save buffer into the nonvolatile memory. All
future power cycles will automatically run the macro.
Redefining the macro with [ESC] g <3> will remove the start-up flag.
Rev Q
Programmer's Guide
11/07/05