TransAct Ithaca 90PLUS Series Programmer's Manual page 58

Printer Control Codes
Print Rotation Commands
Function
ASCII
Hexadecimal
Decimal
IPCL
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Page 46
PcOS Series 90PLUS
Begin 180 rotated print
[ESC] r <2>
1BH 72H 02H
<27> <114> <2>
&%R2
End rotated print
[ESC] r <0>
1BH 72H 00H
<27> <114> <0>
&%R0
[ESC] { <0>
In 90 or 270 mode, the command prints the contents of the rotated print buffer
and returns to normal print orientation. In 180 mode, the printer returns to
normal mode, and the characters in the print buffer that have not been printed
will not be printed.
Set rotated print line length
[ESC] s <n>
1BH 73H <n>
<27> <115> <n>
&%RL <m > <m > <m >
1 2 3
none
The [ESC] s <n> command sets the print line length in autoformat rotated print
mode. The maximum number of characters is 128 per line. The power on default
line length is 80 characters. The number of available print lines is found by
dividing 1760 by the number of characters per line and rounding down to the
nearest whole number. The minimum number is 80 characters. Any value less
than 80 will not allow any additional print lines to be printed. Values greater
than 80 will limit the number of lines to less than 22.
Rev Q
Programmer's Guide
11/07/05