TransAct Ithaca 90PLUS Series Programmer's Manual page 50

Printer Control Codes
Character Attribute Commands
Function
ASCII
Hexadecimal
Decimal
IPCL
IPCL Note
EPOS
Description
EPOS Note
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Page 38
PcOS Series 90PLUS
Multiline, double-wide, and double-high print
[ESC] W <n>
1BH 57H <n>
<27> <87> <n>
&%FD, &%FS, &%FH
Single-wide, double-high mode is not available in IPCL.
[ESC] ! <n>
The [ESC] W <n> command controls multiline, double-wide, and double-high mode.
Where n specifies the mode:
0 Standard single-wide and single-high
1 Begin double-wide
2 Begin double-high
3 Begin double-wide, double-high
Note: The command does not affect line spacing.
[ESC] ! <n> performs a similar function; however, NLQ mode is not available.
Where n bits:
76543210
1-------
--1-----
---1----
-------X
Set print style: double-wide, double-high, and italic control
[ESC] [ @ [EOT] [NUL] <k> [NUL] <n> <m>
1BH 5BH 40H 04H 00H <k> 00H <n> <m>
<27> <91> <64> <04> <0> <K> <0> <n> <m>
&%DH Double-high, double-wide, and double-space
&%SH Single-high, single-wide, and single-space
See also [ESC] W above.
none
The command sets double-wide, double-high, and italic print mode.
Where k bits
76543210
----xxxx
0
----0000
1
----0001
2
----0010
Where n bits
76543210
----xxxx
0
----0000
1
----0001
2
----0010
xxxx----
0
0000----
16
0001----
32
0010----
Where m bits
76543210
----xxxx
0
----0000
1
----0001
2
----0010
Rev Q
Programmer's Guide
&%FS
&%FD
none
&%FH
function
underline
double-wide
double-high
font: 1 = Utility mode; 0 = HSD mode
italic control
no change
italic on
italic off
height multiplier
no change
single-high
double-high
line spacing
no change
single line feed
double line feed
width multiplier
no change
single-wide
double-wide
11/07/05